The box I made with Zach

The box I made with Zach

The box I made with Zach (full size)

(3662/3692)

in Ankeny, Iowa

This photo is part of the Skate Box album and was taken in Ankeny, Iowa.

It's also on Flickr.

Photo Map
I've got 1,446 photos from this spot
1403, Building, Skating

comments

  • how long is it

    james posted

  • 6 ft

    derek posted

  • how tall?

    brandon posted

  • 8 inches like this. I also made a 6 inch booster to raise it up to 14 inches

    derek posted

  • where can you get angle iron from?

    Heinz posted

  • my dad and I are going to build one for scootering. will these plans work for a scooter box? Oh! And i would use it for my master bmx skillz. would the frame be able to sustain the weight of my 15pd. bike?

    Derek posted

  • yes and yes.



    we jump hard on this box all the time, it's very strong. we've had guys skating on this that range from 100-200 pounds.

    derek posted

  • i got both the angle iron and the pole from a hardware store, i believe it was menards.

    derek posted

  • How much did this project cost?

    Derek posted

  • How much did the coping cost? It seems like all the metal i can find for coping is sort of expensive.

    David posted

  • how much did it cost

    jeffrey dahmer posted

  • was this easy to make? i want to make one

    alex posted

  • ya how much did this cost?

    alex posted

  • did u use 2 sheets of 5 ply OR 1 sheet of 7 ply

    LP posted

  • HOW MUCH DID THE ENTIRE THING COST TO MAKE, AND IS THERE SUPPORTS On THE INSIDE OF THE BOX, OH HOW ABOUT THIS....?

    kody posted

  • how wide is it?

    joe posted

  • how wide is it?

    joe posted

  • all of these questions are basically answered here: derek.broox.com/phot...e-box/

    derek posted

  • wat does it mean wen it says 5-21ft 2x4

    adam posted

  • 21 inch, not feet.

    cut 5 2x4s into 21 inch long pieces.

    derek posted

  • its too small to the ground nothing like filming is gonna look good with that its like a curb

    james posted

  • how much did it cost?

    josh posted

  • gay

    james posted

  • how do u mke it

    ben posted

  • where do u get the angled metal? and how much was the angled metal?

    Collin Bogie posted

  • i just got it at a hardware store - menards or home depot should both have it.

    derek posted